Instruction Manual
4
2. Install RJ45 terminated Cat5e/6 Ethernet Cable
a) Connect an RJ45 terminated Cat5e/6 Ethernet cable (not included) to the RJ45
connector on the Transmitter unit.
Note: If you are using surface cabling, ensure you have enough Category 5e
unshielded twisted pair (UTP) network cabling to connect the Host Unit to the
Remote Unit’s location, and that each end is terminated with a RJ45 connector. The
cabling should not go through any networking equipment (i.e. router, switch).
OR
If you are using premises cabling, ensure that the Category 5 unshielded twisted
pair (UTP) network cabling between the Host Unit and the Remote Unit has been
properly terminated in a wall outlet in each location and there is a patch cable long
enough to connect the Remote Unit and the Host Unit to their respective outlets.
The cabling should not go through any networking equipment (i.e. router, switch).
b) Connect the other end of the Cat5e/6 cable run to the RJ45 connector on the
Receiver Unit.
3. Install Receiver Unit
a) Position the Receiver Unit near the video display (i.e. television, projector).
b) Connect the Display to the HDMI out port on the Receiver unit using an HDMI cable.
c) (Optional) If you’ve chosen to connect the power adapter to the Receiver unit,
connect the power adapter from the power adapter port to an available wall outlet.
d) (Optional) If using the Extender to extend up to three 10/100 Network signal(s),
connect up to three Ethernet cable(s) from the LAN Port(s) on the Receiver Unit to
RJ-45 port on your network device(s).
e) (Optional) If using the Extender kit to transmit an infrared (IR) device signal, and the
device receiving the IR signal is on the Transmitter side. Connect the IR Transmitter
Cable to the IR-TX port on the Receiver Unit, and position the IR sensor where the
remote control will point. If the device receiving the IR signal is on the Transmitter
side, and connect the IR Transmitter Cable to the IR-TX port, and position the
extended IR sensor directly in front of the video source’s IR sensor. Check the
manual of your video source device for the IR sensor location.
f) (Optional) If using the Extender kit to transmit a serial signal. Connect a serial cable
(not included) from the serial out port on the Receiver unit to the serial port on the
remote device.
4. Your source video image will now appear on the remote video display.
(11 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels