StarTech.com Remote Cable Tester Manuel d'installation télécharger pdf (Page 5)

Appendix A - LED Indicators

The Remote Cable Tester has a total of 14 LEDs, 9 horizontal indicating each individual

wire inside a cable, and 5 vertical displaying a cable connection status. You can read the

result from the combination of lit horizontal and vertical LEDs.

• S (Yellow) Shielding

• C/1 (Yellow) Center of coaxial cable (BNC) or wire a of TP cable (RJ45), telephone cord

(RJ11) or USB

• 2, 3, 4, ...8 (Yellow) Wire 2, 3, 4, ...8

• Short (Red) Short condition between wires, or between shielding and center of BNC

connector.cable are detected.

• Connected or 25 Ohm (Green) A straight-through connection cable is detected. Or a

standard Ethernet 10Base2 and 10Base5 terminated with 25 Ohm cable is detected.

• Non-parallel or 50 Ohm A non-straight-through connection cable is detected. Or an

Ethernet 10Base2 and 10BAse5 cable with one end termination value (50 Ohm)

is detected.

• No connection/no terminator (Yellow) No cable or terminator is scanned.

• Battery good/battery low (Yellow/Green) It shows the battery status. If LED is green

the battery condition is good, if the LED is yellow the battery condition is poor.

Replace the old battery with a new one when the LED fails to remain lit during

normal operation.

Appendix B

UTP Colour Code

Pair 1 White-Blue (W-BL)

Blue (BL)

Pair 2 White-Orange (W-O)

Orange (O)

Pair 3 White-Green (W-G)

Green (G)

Pair 4 White-Brown (W-BR)

Brown (BR)

Wiring Scheme

T568A T568B

1 W-G 1 W-O

2G 2O

3 W-O 3 W-G

4BL 4BL

5 W-BL 5 W-BL

6O 6G

7 W-BR 7 W-BR

8BR 8BR

1 2 3 4 5

Pas de commentaire

StarTech.com Remote Cable Tester Manuel d'installation Page 5