StarTech.com NETRS232 Manuel d'utilisateur Page 3
- Page / 8
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2
Hardware Setup
1. Connect the power supply to the NETRS232 and to AC power.
2. The power (red) LED will light to indicate that the unit is receiving power.
3. Connect a network cable to the Ethernet RJ-45 jack of the NETRS232.The other end
of the network cable can be attached to either:
• an Ethernet hub or switch, using a length of standard Ethernet network cable
• a host PC directly, using an Ethernet cross-over cable.
Network status is indicated by two LEDs on the RJ-45 connector.The left (yellow) LED
indicates network activity. It is on by default, turning off when network activity occurs
at the NETRS232.The right (green) LED indicates a network link.It is off by default, but
lights when a network link exists.
4. Connect a serial device to the NETRS232.
Serial port activity is indicated by two status LEDs per port. The yellow LED lights when
the serial port is transmitting data.The green LED lights when the serial port is
receiving data.
Power
connector
Single Port Dual Port
Power
indicator
Network
connector (RJ-45)
Network
Activity and Link
indicators
Serial connector
(DB-9 shown)
Serial Tx
indicator
Serial Rx
indicator
Serial 1
connector
(DB-9 shown)
Serial 2
connector
(DB-9 shown)
Serial Tx
indicators
Serial Rx
indicators
Produits connexes et manuels pour Cartes/adaptateurs d'interface StarTech.com NETRS232
(13 pages)Yamaha CDX-490 manuels
Manuels d'utilisation et guides de l'utilisateur pour Lecteurs de CD Yamaha CDX-490.
Nous fournissons des manuels en pdf 1 Yamaha CDX-490 à télécharger gratuitement par type de document : Manuel du propriétaire
Commentaires sur ces manuels