StarTech.com PEXSAT34SFF Manuel d'instructions télécharger pdf (Page 14)

Instruction Manual

HyperDuo Conguration

HyperDuo oers the following two modes that you can congure using either of the

procedures outlined in the following sections:

• Safe mode creates a virtual disk that is optimized for best fault tolerance – the

frequently accessed les copied to the SSD for performance are also stored on the

HDD. It is safe to use with hard drives that contain existing data. Virtual disks created

in safe mode can also be partially rebuilt if the SSD fails, but not if the HDD fails.

• Capacity mode creates a virtual disk that is optimized for maximum utilization of

the SSD – the frequently accessed les are moved to the SSD (not copied). Virtual

disks created in capacity mode have better read and write performance than those

created in safe mode. However, they cannot be rebuilt.

WARNING! Capacity mode is a data-destructive process. Please back up all data before

using capacity mode.

Card BIOS Method

1. When prompted on startup, press Ctrl+M to enter the card BIOS utility

Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue_

2. Using the arrow keys to navigate, move to “HBA0: Marvell 0” and press Enter

to select

3. Press Enter again to open the Conguration Wizard

4. Use the arrow keys to scroll through the list of free physical disks to select the drives

that will be part of the HyperDuo set. Press Space to select/de-select a disk.

NOTE: When a disk is selected, an asterisk (*) appears to the left of the disk label.

5. After selecting the required disks, press Enter to continue.

6. The “Create Virtual Disk” conguration options appear in the “Information” pane

(right-side), here you are able to select HyperDuo or RAID options

NOTE: The default HyperDuo mode is Safe mode.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

StarTech.com PEXSAT34SFF Manuel d'instructions Page 14