StarTech.com R300WN22OP5G Manuel d'instructions télécharger pdf (Page 7)

Instruction Manual

LED Indicators

Indicator State Description

PWR

ON The device is powered on

OFF The device is powered o

LAN 2

ON Link detected

OFF No link detected

Flashing Data is being transmitted / received on the LAN 2 interface

LAN 1

ON Link detected

OFF No link detected

Flashing Data is being transmitted / received on the LAN 1 interface

Wi

Activity

Indicators

Wireless client(s) are connected. Shows signal strength for

best connected client/AP

OFF No connected wireless client(s)

Installation

Preparing Your Site

1. Determine the location for the included PoE injector and mount using the

appropriate screws/anchors for the material you are mounting to (not included).

2. Determine the location for the Wireless AP. If you are pole-mounting the AP, use

the included clamp to secure the device. If you are wall mounting the AP, use the

appropriate screws/anchors for the material you are mounting to (not included).

3. Prepare/purchase the required length of Ethernet cabling to go from the PoE

Injector to your LAN Switch or router, and from PoE Injector to the AP.

Note: The total length of Ethernet cabling from the Wireless AP to your LAN switch

or router should not exceed 100m

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

StarTech.com R300WN22OP5G Manuel d'instructions Page 7