StarTech.com NETRS2321P Manuel d'instructions télécharger pdf (Page 12)

Instruction Manual

Load default setting

On this page, you can load and store the factory default settings into EEPROM.

NOTE: Network settings and MAC address will not be changed.

Press “Load” to load default settings. Reset the device to take eect.

Firmware update

On this page, you can update the rmware via Ethernet.

WARNING! Pressing the ‘Load’ button will immediately erase the ash with no

further warning

1. Pressing the “Load” button will erase ash.

2. Wait for erase process to complete.

3. There are two methods to do the Firmware Update action (TFTP or Web):

NOTE: Please avoid loss of network connection, power or other interruption during

the rmware upgrade procedure

Web

a. Please type in or browse the target image le in the input eld, and then press

“update” button to continue.

TFTP

a. Use Windows Command Prompt window to run the tftp client program.

Syntax: tftp -i 10.1.1.1 put FILE_DIRECTORY\FILENAME.bin

b. The rmware update should take about 45 seconds to complete.

c. If the update process somehow goes wrong (like power failure), please connect

to http://10.1.1.1 to try and restart the process (you may have to reset the

device rst)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

StarTech.com NETRS2321P Manuel d'instructions Page 12