StarTech.com NETRS2321P Manuel d'instructions télécharger pdf (Page 17)

Instruction Manual

Hardware Flow Control

Set the ow control mode of UART interface as enabled or as none.

UART Memory Overow count

Shows the number of overow bytes in network buer.

UART FIFO Overow count

Shows the number of overows counted in the UART RX buer.

Delimiter

This sets the Character 1 and/or Character 2 to be used as the delimiter. When

sending data from serial to TCP the data is rst stored in the cache. When set, not until

the value of character 1 or 2 is received from the serial side is the data released from

the cache and sent to TCP.

Silent time - If there is no data sent or received for the number of milliseconds

specied the connection is dropped.

The Drop Character drops the delimiter character of the serial port when sending to

TCP, (the receiver doesn't display the character).

Reset Device

Pressing the “Reset” button will force the NETRS2321P to do system reset action.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

StarTech.com NETRS2321P Manuel d'instructions Page 17